문제 및 해결책

일반적인 플라스틱 재료 문제에 대한 실질적인 답변

기사 둘러보기 →

Uneven Surface of ABS Variant Extruded Pipe

Extrusion & Post uneven surfacepipeABS variantextrusion moldingsurface quality

Fiber diameter fluctuation along the length direction

Fiber diameter requires stable spinning parameters

Extrusion & Post fiber diameterspinning stabilitymetering pump

Uneven fiber color

Fiber color difference needs to be addressed from dispersion and temperature

Extrusion & Post fiber color differencecolor masterbatch dispersiontemperature stability

Influence of draw ratio, temperature, and speed on fiber performance

Extrusion & Post spinning drawingdraw ratioorientationsetting

POM surface decoration is difficult

POM surface decoration requires pre-treatment.

Extrusion & Post POMsurface treatmentprintingadhesionplasma

POM melt fracture and rough surface

POM melt fracture is the consequence of over-shearing.

Extrusion & Post POMmelt fracturesurfacesheartemperature

Adhesive layer problem of PLA multilayer coextrusion

PLA multilayer film adhesion is a key process point.

Extrusion & Post PLAmultilayer coextrusionadhesive layer

Deformation of PLA products during annealing treatment

PLA annealing deformation requires fixture and rate control.

Extrusion & Post PLAannealingdeformationfixture

PLA screw configuration design

PLA screws need dedicated design.

Extrusion & Post PLAscrewconfigurationlow shear

High film breakage rate of PLA biaxially stretched film

PLA biaxial stretching film breakage rate is higher than traditional polyester.

Extrusion & Post PLAbiaxial stretchingfilm breakagedraw ratio

이전 1 2 3 4 5 6 7 8 ... 224 다음