Processing Machinery
2 Aufrufe
PC/ABS silver streak (air entrapment type)
Problembeschreibung
Silver streaks are scattered and jet-like, reduced after increasing back pressure.
Ursachenanalyse
Back pressure too low, air is sucked in when the screw retracts; the nozzle contact surface gap also draws in air to form jet streaks.; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based on experience alone
Lösung
①Increase back pressure; ②reduce screw suck-back distance; ③check nozzle contact seal; ④adjust anti-drool amount.; after adjustment, take continuous samples to verify the effect, and resume mass production only after confirming stability
Wichtigste Erkenntnis
Air-type silver streaks have a scattered form; back pressure and nozzle seal are the troubleshooting points.; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a troubleshooting reference for similar problems later
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!