Material Analysis
10 Aufrufe
PC melt temperature window 280-320℃
Problembeschreibung
Products turn yellow and have black specks, or are underfilled with obvious weld lines
Ursachenanalyse
When the melt is below 280℃, viscosity is high, filling is difficult and internal stress is high; above 320℃, PC thermal degradation intensifies, molecular chain scission produces yellowing, black specks and gas, and performance deteriorates across the board
Lösung
①Melt temperature set at 280-320℃, general-purpose grade at 270-300℃; ②Reinforced and flame-retardant grades take the upper limit; ③Use measured melt temperature to calibrate barrel set values
Wichtigste Erkenntnis
The PC melt temperature window is narrow and high; 280-320℃ is the core range balancing fluidity and degradation prevention, and measured calibration cannot be omitted；After confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!