Flow Marks Appearing on the Surface of Block Copolymer Polypropylene Injection Molded Products (Variant: Strengthened Measures)

Concentric circular or wavy stripes centered on the gate appear on the product surface, i.e., flow marks. The surface at the flow marks is rough, and the color may be slightly different, affecting the appearance quality of the product, mostly seen in high-gloss products. In particular, extra attention is needed on the original basis; this problem is more prominent and requires key attention.

（1）When the melt flows in the cavity, the front temperature repeatedly rises and falls, forming alternating hot and cold flow marks （2）The injection speed is too slow or unstable, and the melt front stagnates intermittently during mold filling （3）The mold temperature is too low, and the melt cools rapidly after contacting the mold wall, forming a cold material layer （4）The barrel temperature is set improperly, and the nozzle temperature is low, producing cold material （5）The mold gate size is too small, and the melt generates shear heat and pressure loss when passing through the gate （6）On the original basis, extra attention is needed: process parameter fluctuations or equipment status changes have aggravated this problem

（1）Increase the injection speed, adopt multi-stage injection, and maintain a stable speed front during mold filling （2）Increase the mold temperature to a higher value within the 40-90°C range to reduce the melt temperature drop （3）Increase the nozzle temperature to be consistent with the front barrel temperature or 5-10°C higher to prevent cold material （4）Increase the gate size to reduce the shear and pressure loss when the melt passes through the gate （5）Appropriately increase the barrel temperature to a higher value within the 200-270 range （6）And strengthen process monitoring; on the original basis, extra attention is needed, with special attention to parameter stability

Flow marks are a manifestation of an unstable melt flow front, and the flow front is stabilized by increasing the injection speed, mold temperature, and melt temperature. Targeted preventive measures need to be taken in different production scenarios.