Problema y solución

Q

Rough inner and outer walls of heat-resistant polyethylene pipes (Variant: strengthened measures)

A

Pipe wall roughness is caused by low mold temperature or poor surface condition, and needs to be solved from temperature control and mold maintenance. Targeted preventive measures need to be taken in different production scenarios.

Material Drying pipe wall roughnessdie temperaturemandrel temperaturemold polishingsizing sleeve

Q

Improper production environment control during processing of heat-resistant polyethylene heat-resistant polyethylene (Variant: strengthened measures)

A

The production environment is an important factor affecting the processing quality, and a sound environmental control system needs to be established. In different production scenarios, targeted preventive measures need to be taken.

Material Drying environmental control workshop temperature humidity cooling water temperature process stability

Q

Bubbles/gas pores on the surface of heat-resistant polyethylene extruded products (Variant: mass production scenario)

A

Bubbles are caused by water vaporization or gas entrainment, and need to be solved from raw '2079851475616104451 and venting system. In different production scenarios, targeted preventive measures need to be taken.

Material Drying bubble gas pore raw '2079851475616104451 venting volatiles

Q

Defects caused by insufficient drying before processing of heat-resistant polyethylene heat-resistant polyethylene (Variant: strengthened measures)

A

Insufficient drying is a common root cause of processing defects, and a sound drying system and moisture content inspection system need to be established. In different production scenarios, targeted preventive measures need to be taken.

Material Drying raw '2079851475616104451 moisture content silver streak bubble dehumidifying drying

Q

Bubbles/gas pores on the surface of heat-resistant polyethylene extruded products (Variant: strengthened measures)

A

Bubbles are caused by water vaporization or gas entrainment, and need to be solved from raw '2079851475616104451 and venting system. In different production scenarios, targeted preventive measures need to be taken.

Material Drying bubble gas pore raw '2079851475616104451 venting volatiles

Q

Rough inner and outer walls of general-purpose polyethylene pipes

A

Rough pipe wall is caused by low mold temperature or poor surface condition, and needs to be solved from temperature control and mold maintenance.

Material Drying rough pipe wall die temperature mandrel temperature mold polishing sizing sleeve

Q

Improper production environment control during processing of general-purpose polyethylene general-purpose polyethylene

A

The production environment is an important factor affecting the processing quality, and a sound environmental control system needs to be established.

Material Drying environmental control workshop temperature humidity cooling water temperature process stability

Q

Defects caused by insufficient drying before processing of general-purpose polyethylene general-purpose polyethylene

A

Insufficient drying is a common root cause of processing defects, and a sound drying system and moisture content inspection system need to be established.

Material Drying raw '2079851475616104451 moisture content silver streak bubble dehumidifying drying

Q

Bubbles/gas pores on the surface of general-purpose polyethylene extruded products

A

Bubbles are caused by water vaporization or gas entrainment, and need to be solved from raw '2079851475616104451 and venting system.

Material Drying bubble gas pore raw '2079851475616104451 venting volatiles

Q

Excessive moisture content of general-purpose polyethylene raw material causing product defects

A

Excessive moisture content of the raw material is solved by sufficient drying, and a sound drying and storage management system needs to be established.

Material Drying moisture content drying silver streak bubble moisture-proof storage

Problema y solución

Categorías

Solicitar presupuesto