Blow Molding
12 조회수
HDPE drum '2079851475616104457 wall thickness unevenness
문제 현상
The wall thickness distribution of the hollow blow molded drum is uneven, the shoulder and bottom are thin, and the drop test breaks at the thin areas.
원인 분석
Parison sag unbalances the axial wall thickness distribution; excessive blow-up ratio or uneven parison temperature also causes local thinning.; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based on experience alone
해결 방법
①Enable parison wall thickness program control; ②reduce parison temperature fluctuation; ③optimize the blow-up ratio design; ④adjust the pre-blowing and blowing timing.; after adjustment, take consecutive samples to verify the effect, and resume mass production only after confirming stability
핵심 요약
Hollow drum wall thickness relies on parison program and temperature management; wall thickness program control is the core configuration of extrusion '2079851475616104457.; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!