Extrusion & Post
4 조회수
LDPE Film Wet Marks
문제 현상
Cast film surface shows wet-mark water-stain-like defects, appearance is downgraded, and temperature adjustment gives inconsistent results
원인 분석
Wet marks are a sign that the film cooling rate is too slow: melt temperature too high, chill roll temperature high, and line speed fast cause the film to not be fully cooled before leaving the roll surface, and the surface shows wet marks
해결 방법
① Lower the chill roll temperature in 5℃ steps but not below the lower limit of 15℃; ② reduce extrusion and line speed to reduce cooling load; ③ lower the die lip temperature in 3℃ steps; after adjustment, take continuous samples to verify the effect, and resume mass production only after confirming stability
핵심 요약
The radical cure for LDPE film wet marks lies in the cooling rate; roll temperature, speed, and die lip temperature are three parameters linked to lower the temperature; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!