Injection Molding
6 조회수
PARA Injection Pressure and Glass Fiber
문제 현상
PARA injection pressure is set improperly; insufficient pressure gives poor filling, excessive pressure gives warpage, difficult demolding and flash.
원인 분석
Higher injection pressure benefits filling, improves glass fiber dispersion and reduces shrinkage, but increases shear stress and orientation, easily causing warpage deformation, demolding difficulty and even flash; the higher the glass fiber content and the longer the length, the greater the injection pressure should be.
해결 방법
①Appropriately increase on the basis of slightly higher than non-reinforced plastic injection pressure; ②Adjust according to glass fiber content and length; ③Weigh filling against warpage and demolding; ④Multi-stage injection balancing.
핵심 요약
PARA injection pressure is a balance between filling and side effects; glass fiber content and length are the pressure setting basis; multi-stage injection is the optimization means.; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!