Injection Molding
6 조회수
PCABS holding pressure ratio setting
문제 현상
【Problem Phenomenon】PC/ABS holding pressure improper, sink marks and internal stress problems alternate
원인 분석
Holding pressure is 50-70% of injection pressure: compensates 0.5-0.7% shrinkage to prevent sink marks; excessive holding pressure introduces internal stress, especially sensitive in the PC phase; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based on experience alone
해결 방법
Set holding pressure at 50-70%; extend time in thick-wall areas; reduce holding pressure for internal stress parts with annealing; after adjustment, take continuous samples to verify the effect, and resume mass production only after confirming stability
핵심 요약
PC/ABS holding pressure 50-70%, balancing sink marks and stress at both ends; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a troubleshooting reference for similar problems later
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!