Injection Molding
6 조회수
PCABS Flash Overflow
문제 현상
[Problem Phenomenon] PC/ABS parting line flash increases trimming cost
원인 분석
Excessive injection pressure, insufficient clamping, and parting line wear; PC/ABS has better flow than pure PC and is more prone to flash; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based only on experience
해결 방법
Reduce injection pressure and holding pressure; verify clamping force; repair parting line fit; after adjustment, continuously sample to verify the effect, and resume mass production after confirming stability; change only one variable at a time and record parameter changes to facilitate locating effective measures
핵심 요약
For PC/ABS flash, first reduce pressure, then check clamping and the parting line; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a troubleshooting reference for similar problems in the future
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!