Injection Molding
6 조회수
PC Flow Marks
문제 현상
[Problem Phenomenon] Wavy flow marks on the PC surface
원인 분석
The front cold film ruptures; PC's high viscosity, low mold temperature and slow injection speed aggravate it; when troubleshooting on site, verify each item according to this mechanism one by one, and avoid blindly adjusting the machine based on experience alone; this mechanism has been repeatedly verified by industry data and should be confirmed first during troubleshooting
해결 방법
Increase the mold temperature and melt temperature; multi-stage injection optimization; enlarge the runner and gate; after adjustment, take samples continuously to verify the effect, and resume mass production only after confirming stability; change only one variable at a time and record parameter changes, so as to locate effective measures
핵심 요약
For PC flow marks, raise the temperature and stabilize the speed; high viscosity is the internal cause; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a reference for troubleshooting similar problems in the future
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!