Material Drying
3 조회수
PPO Extrusion Bubbles
문제 현상
[Problem Phenomenon] Internal bubbles in PPO extruded profiles, density not up to standard
원인 분석
Insufficient drying causes moisture vaporization or poor venting section performance entrains gas; PPO extrusion requires a vented extruder to discharge volatiles; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based only on experience
해결 방법
Strengthen drying according to extrusion grade requirements; check vent port vacuum and smoothness; lower the feeding section temperature to prevent early melting and gas entrainment; after adjustment, take continuous samples to verify the effect, and resume mass production only after confirming stability
핵심 요약
For PPO extrusion bubbles check drying and the venting section; vacuum is the key; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a reference for troubleshooting similar problems in the future
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!