Processing Machinery
3 조회수
Excessive Shear from PSU Screw Speed
문제 현상
After increasing screw speed to improve plasticization, PSU shows shear overheating and degradation; the medium speed requirement was ignored; product performance declined.
원인 분석
PSU screw speed is recommended at medium speed to prevent excessive shear, recommended 45~55; high-viscosity melt generates significant shear heat; excessive shear breaks molecular chains.; During on-site troubleshooting, verify item by item according to this mechanism, avoiding blindly adjusting the machine based solely on experience
해결 방법
①Control screw speed in the 45~55 medium range; ②Prevent excessive shear; ③For insufficient plasticization, prioritize raising temperature rather than speed; ④Monitor measured melt temperature.; After adjustment, continuously sample to verify the effect, and resume mass production only after confirming stability
핵심 요약
The 45~55 for PSU screw speed is the quantitative definition of medium speed; shear heat management is a common topic for high-viscosity materials; measured temperature is the referee.; After confirming effectiveness, solidify the parameters and practices into the work instructions to prevent recurrence
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!