Injection Molding
6 조회수
PSU Screw Configuration and Rotation Speed
문제 현상
[Problem Phenomenon] General-purpose screws processing PSU have heavy plasticization load and uneven melt; equipment alarms
원인 분석
PSU suits a single-flighted full-thread constant-pitch low-compression-ratio screw with L/D ratio of 14-20; high viscosity requires the '2079851475616104452 machine to be equipped with a low-gear speed regulation device with stepless regulation at 15-45rpm to reduce screw load
해결 방법
Configure the screw with L/D 14-20 low compression ratio; control screw speed at 15-45rpm; when plasticization is insufficient, prioritize raising external heat rather than speed; after adjustment, continuously sample to verify the effect, and resume mass production only after confirming stability
핵심 요약
PSU screws need low compression ratio L/D 14-20 paired with 15-45rpm low-speed plasticization; After confirming effectiveness, solidify the parameters and practices into the work instructions to prevent recurrence
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!