Extrusion & Post
10 조회수
Longitudinal streaks in EAA extruded film
문제 현상
Continuous streaks 1-3mm wide along the extrusion direction on the surface of EAA extruded film
원인 분석
Local damage to the die lip or uneven gap; unstable flow in the melt stagnation zone inside the die; pressure fluctuation at the front end of the screw
해결 방법
1) Check the flatness of the die lip and gap uniformity ±0.01mm; 2) Clean the inside of the die to remove carbonized material in the stagnation zone; 3) Install a gear pump on the extruder to stabilize melt pressure; 4) Polish the die lip to Ra<0.1μm
핵심 요약
Longitudinal streaks are caused by die defects and pressure fluctuations; die maintenance and pressure stability are the key
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!