Injection Molding
3 조회수
EVOH injection warpage deformation
문제 현상
EVOH injection molded product warps 2-3mm/100mm after demolding, flatness not meeting standard
원인 분석
EVOH shrinkage rate is large and mold temperature uneven, causing shrinkage differences in all directions; improper gate position with uneven release of flow orientation stress; insufficient cooling time
해결 방법
1) Increase mold temperature to 40-60°C to reduce temperature differences; 2) Increase holding pressure to 50-70MPa; 3) Optimize gate position for uniform flow; 4) Extend cooling time; 5) Annealing treatment to release residual stress
핵심 요약
Warpage is caused by shrinkage differences and orientation stress; uniform mold temperature and holding pressure are key
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!