Material Drying
4 조회수
CMC injection thick wall bubbles
문제 현상
Dense bubbles of 0.1-0.5mm appear inside the CMC injection thick-walled product, concentrated in the center of the wall thickness
원인 분석
The holding pressure is insufficient <40MPa or the holding pressure time is short and the center of the thick wall is not compacted; the raw material contains moisture; the injection speed is too fast and air is entrapped; the mold venting is poor
해결 방법
1) Increase the holding pressure to 60-80MPa; 2) Extend the holding pressure time to fully compact the thick wall; 3) Fully dry the raw material to a moisture content <0.02%; 4) Add vent grooves or vent pins to the mold; 5) Gradually decelerate the injection to avoid air entrapment
핵심 요약
Thick wall bubbles are caused by a combination of insufficient holding pressure, moisture and poor venting
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!