Injection Molding
4 조회수
Blockage of Cooling Water Channels in High-Density Polyethylene Injection Molds
문제 현상
The cooling effect of the mold decreases, the cooling time is extended, and the demolding temperature of the product increases.
Blockage of the cooling water channels leads to poor local cooling, defects such as warpage and shrinkage cavities in the product, and reduced production efficiency.
원인 분석
（1）The cooling water quality is poor, and scale gradually builds up on the inner wall of the water channels and blocks them
（2）The water channel design is unreasonable, with dead corners where impurities easily deposit
（3）No cleaning and maintenance for a long time, and the water channels rust or corrode
（4）The coolant temperature is too low, causing condensation, and water mixes into the water channels
（5）The water channel joints leak, and air enters to form air locks
해결 방법
（1）Regularly clean the cooling water channels, and descale with chemical cleaning agents every 3-6 months
（2）Use soft water or pure water as the cooling medium, and add preservatives
（3）Optimize the water channel design to avoid dead corners and excessively small channel diameters (≥8mm)
（4）Control the coolant temperature 2-3°C higher than room temperature to prevent condensation
（5）Check the sealing of the water channel joints to ensure no leakage and no air locks
핵심 요약
Water channel blockage is caused by poor water quality and insufficient maintenance, and the water channels need to be cleaned regularly and the cooling water quality improved.
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!