Injection Molding
4 조회수
Large injection pressure fluctuation in low density polyethylene '2079851475616104452
문제 현상
During injection, the pressure gauge reading fluctuates greatly, and the pressure difference within the same cycle or between different cycles exceeds ±5%.
Pressure fluctuation causes unstable product weight, dimensions, and quality; in severe cases, short shots or flash appear alternately.
원인 분석
(1) Unstable hydraulic system pressure, hydraulic pump wear or hydraulic oil contamination
(2) Screw non-return ring wear, inconsistent injection amount each time
(3) Large barrel temperature fluctuation; melt viscosity changes cause pressure fluctuation
(4) Uneven feeding, inconsistent plasticizing amount each time
(5) Unstable screw rotation speed, fluctuating plasticizing quality
해결 방법
(1) Check the hydraulic system, repair or replace the worn hydraulic pump, replace hydraulic oil
(2) Check the non-return ring; replace if wear exceeds 0.1mm
(3) Stabilize barrel temperature; control fluctuation of each zone within ±3°C (160-220°C range)
(4) Check the feeding system, ensure smooth hopper feeding and stable material level
(5) Stabilize screw rotation speed and back pressure, ensure plasticizing consistency
핵심 요약
Injection pressure fluctuation is caused by hydraulic system instability or plasticizing inconsistency; the hydraulic, screw, and temperature control systems need to be systematically investigated.
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!