Extrusion & Post
4 조회수
Ovality of linear low-density polyethylene pipes exceeding standard (variant: strengthened measures)
문제 현상
The pipe cross-section is not round, and ovality exceeds the tolerance.
Ovality exceeding the standard affects pipe connection and installation, and may cause leakage in socket connections and mechanical connections.
Especially, additional attention is needed on top of the original basis; this problem is more prominent and requires focused attention.
원인 분석
(1) Uneven cooling causes inconsistent shrinkage in all directions of the pipe
(2) The sizing sleeve is worn or installed incorrectly
(3) Excessive haul-off machine clamping force causes pipe deformation
(4) Improper pipe stacking causes deformation
(5) Excessive cooling water temperature causes pipe softening and deformation
(6) On top of the original basis, additional attention is needed as process parameter fluctuations or equipment condition changes aggravate this problem
해결 방법
(1) Check the cooling system to ensure uniform cooling in all directions of the pipe
(2) Check the sizing sleeve; replace if worn and ensure concentric installation
(3) Adjust the haul-off machine clamping force to avoid being too large
(4) Use special storage racks for pipes to avoid stacking deformation
(5) Control cooling water temperature at 15-25°C
(6) And strengthen process monitoring; on top of the original basis, additional attention is needed to pay special attention to parameter stability
핵심 요약
Ovality exceeding the standard is caused by uneven cooling or external force deformation and needs to be solved from cooling uniformity and pipe storage.
In different production scenarios, targeted preventive measures need to be taken.
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!