Extrusion & Post
4 조회수
Melt flow rate mismatch of raw materials for heat-resistant polyethylene extrusion (Variant: strengthened measures)
문제 현상
After using a certain batch of raw material, the extrusion process parameters need to be greatly adjusted, and the product quality fluctuates.
The MFR mismatch makes the original process parameters inapplicable, affecting production efficiency.
In particular, extra attention is needed on the original basis, this problem is more prominent and needs key attention.
원인 분석
（1）The raw material MFR is low, the extrusion energy consumption is large, and the output is low
（2）The raw material MFR is high, and the mechanical properties of the product decrease
（3）Different grades of raw materials are mixed, and the MFR is inconsistent
（4）The raw material has been stored for too long, and the MFR has changed
（5）The MFR fluctuates greatly between batches of raw materials
（6）On the original basis, extra attention is needed: process parameter fluctuations or equipment status changes have aggravated this problem
해결 방법
（1）Select an extrusion grade with suitable MFR, heat-resistant polyethylene extrusion usually selects MFR 0.3-5g/10min
（2）Test the MFR of each batch of raw material and match it with the process requirements
（3）Avoid mixing different grades, and do a test first when mixing is necessary
（4）Use the raw material within the shelf life
（5）When the MFR is low, appropriately raise the barrel temperature
（6）When the MFR is high, appropriately lower the barrel temperature
（6）And strengthen process monitoring; on the original basis, extra attention is needed, with special attention to parameter stability
핵심 요약
MFR mismatch needs to be solved by selecting suitable grades and adjusting temperature parameters.
In different production scenarios, targeted preventive measures need to be taken.
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!