Extrusion & Post
4 조회수
Die head pressure fluctuation of polyolefin plastomer extruders (Variant: Enhanced Measures)
문제 현상
The reading of the die head pressure gauge fluctuates greatly and the pressure is unstable.
Die head pressure fluctuation directly causes dimensional fluctuation and surface defects of the extrudate and is an important indicator of extrusion instability.
In particular, additional attention is needed on the original basis; this problem is more prominent and requires focused attention.
원인 분석
（1）The screw discharge is uneven and the melt pressure fluctuates
（2）The screen is clogged or damaged
（3）The die head temperature fluctuates greatly and the melt viscosity changes
（4）The breaker plate is deformed or improperly installed
（5）The raw material contains many impurities, frequently clogging the screen
（6）On the original basis, additional attention is needed: fluctuations in process parameters or changes in equipment status have aggravated this problem
해결 방법
（1）Stabilize the screw speed and barrel temperature to ensure uniform discharge
（2）Replace the screen regularly and establish a replacement cycle
（3）Stabilize the die head temperature, with the fluctuation controlled within ±3°C (180-230°C range)
（4）Check the breaker plate; replace it if deformed, and ensure it is installed in place
（5）Screen the raw material before use, and install a magnetic frame on the hopper to remove impurities
（6）And strengthen process monitoring; on the original basis, additional attention is needed to pay special attention to parameter stability
핵심 요약
Die head pressure fluctuation is caused by unstable discharge or filtration system problems, and it is necessary to stabilize the extrusion parameters and maintain the filtration system.
Targeted preventive measures need to be taken in different production scenarios.
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!