Material Drying
11 조회수
Random copolymer polypropylene pipe special material (Nordic standard） extruded products surface bubbles/pores（Variant: Mass Production Scenario）
문제 현상
Bubbles or pores appear on the extrudate surface or cross-section, and the product density decreases.
Bubbles not only affect appearance, but also reduce product mechanical strength and pressure resistance, common in pipe and profile extrusion.In particular, during continuous mass production, this problem is more prominent and requires key attention.
원인 분석
（1）The raw material moisture content exceeds the standard, moisture vaporizes at high temperature producing bubbles\
（2）Poor screw venting, air entrained in the melt\
（3）Barrel temperature too high, material thermally degrades producing gas\
（4）Screw speed too fast, venting time insufficient\
（5）The low-molecular volatile content in the raw material is high\
（6）In continuous mass production, process parameter fluctuations or equipment status changes aggravate this problem
해결 방법
（1）Fully dry the raw material, control the moisture content of the random copolymer polypropylene pipe special material (Nordic standard） below 0.02%\
（2）Check the venting section design, use a vented extruder if necessary\
（3）Appropriately lower the barrel temperature to a reasonable value within the 200-220°C range\
（4）Reduce screw speed, increase the material residence time in the venting section\
（5）Select raw material grades with low volatile content\
（6）And establish standardized work instructions, paying special attention to parameter stability in continuous mass production
핵심 요약
Bubbles are caused by moisture vaporization or gas entrainment, and need to be solved from raw '2079851475616104451 and the venting system.Targeted preventive measures need to be taken in different production scenarios.
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!