Injection Molding
5 görüntüleme
ASA injection speed and shear
Sorun Belirtisi
[Problem phenomenon] ASA injection speed improper, jetting marks and short shots appear alternately
Neden Analizi
ASA medium viscosity medium shear sensitivity, injection speed medium-high is appropriate: too slow causes front freezing and short shots, too fast causes shear heat generation and discoloration; long runner thin wall needs 200mm/s level high speed
Çözüm
Injection speed set at medium-high and staged; long runners use high speed with venting; reduce speed and check gate when discoloration or jetting occurs; after adjustment, continuously sample to verify the effect, and resume mass production after confirming stability
Temel Çıkarım
ASA injection medium-high speed is appropriate, long runner 200mm/s level with venting; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!