Processing Machinery
4 görüntüleme
PLA Screw Selection
Sorun Belirtisi
Using a polyolefin extruder near maximum power to process PLA, torque is insufficient and plasticization is poor
Neden Analizi
PLA recommends a general-purpose screw with L/D 24-30 and compression ratio 2-3; polyolefin extruders running near maximum power have insufficient torque reserve; polyester or PS extruders are more suitable
Çözüm
①Select an L/D24-30, compression ratio 2-3 general-purpose screw; ②Use a polyester or PS type extruder; ③Avoid running the equipment at the full-load boundary; after adjustment, take continuous samples to verify the effect, and resume mass production only after confirming stability
Temel Çıkarım
PLA screw selection follows polyester; L/D24-30 plus compression ratio 2-3 is the standard configuration, and torque reserve must be sufficient; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!