Extrusion & Post
11 görüntüleme
Gel particles in PU extruded film
Sorun Belirtisi
0.1-0.5mm transparent gel particles appear on the surface of PU extruded film
Neden Analizi
High molecular weight components in PU are not fully melted during extrusion, forming local highly crystalline regions; extrusion temperature too low or insufficient mixing
Çözüm
1) Increase extrusion temperature by 5-10°C to ensure full melting; 2) Increase screw mixing section length; 3) Inspect raw material to ensure consistent grade; 4) Replace with finer 120 mesh screen to intercept unmelted particles
Temel Çıkarım
Gel particles are caused by insufficient melting; increasing temperature and mixing are key
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!