Extrusion & Post
11 görüntüleme
Glass Fibre extruded pipe rough inner wall
Sorun Belirtisi
Glass Fibre extruded pipe inner wall roughness Ra>10μm, affecting fluid transport efficiency
Neden Analizi
Mandrel surface rough or worn; insufficient internal cooling causes inner wall melt not fully set; Glass Fibre melt elasticity causes uneven extrusion swell of inner wall
Çözüm
1) Polish mandrel to Ra<0.4μm; 2) optimize internal cooling system, cooling water through mandrel; 3) reduce extrusion rate to reduce elastic recovery influence; 4) add small amount of low-elasticity resin to improve inner wall smoothness
Temel Çıkarım
Pipe inner wall roughness is caused by mandrel condition and insufficient cooling; polishing mandrel and internal cooling are key
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!