Extrusion & Post
5 görüntüleme
Head pressure fluctuation of linear low-density polyethylene extruder (variant: strengthened measures)
Sorun Belirtisi
The head pressure gauge reading fluctuates greatly and the pressure is unstable.
Head pressure fluctuation directly causes extrudate dimensional fluctuation and surface defects and is an important indicator of extrusion instability.
Especially, additional attention is needed on top of the original basis; this problem is more prominent and requires focused attention.
Neden Analizi
(1) Screw output is uneven and melt pressure fluctuates
(2) The screen is clogged or damaged
(3) Head temperature fluctuates greatly and melt viscosity changes
(4) The breaker plate is deformed or improperly installed
(5) The raw material contains many impurities, frequently clogging the screen
(6) On top of the original basis, additional attention is needed as process parameter fluctuations or equipment condition changes aggravate this problem
Çözüm
(1) Stabilize screw speed and barrel temperature to ensure uniform output
(2) Regularly replace the screen and establish a replacement cycle
(3) Stabilize head temperature, controlling fluctuation within ±3°C (190-250°C range)
(4) Check the breaker plate; replace if deformed and ensure proper installation
(5) Sieve the raw material before use, and install a magnetic rack on the hopper to remove impurities
(6) And strengthen process monitoring; on top of the original basis, additional attention is needed to pay special attention to parameter stability
Temel Çıkarım
Head pressure fluctuation is caused by unstable output or filtration system problems; extrusion parameters need to be stabilized and the filtration system maintained.
In different production scenarios, targeted preventive measures need to be taken.
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!