Extrusion & Post
6 görüntüleme
Ovality of polyolefin plastomer pipes exceeding the standard (Variant: Enhanced Measures)
Sorun Belirtisi
The pipe cross section is not round and the ovality exceeds the tolerance.
Excessive ovality affects pipe connection and installation, and may cause leakage in socket connections and mechanical connections.
In particular, additional attention is needed on the original basis; this problem is more prominent and requires focused attention.
Neden Analizi
（1）Uneven cooling causes inconsistent shrinkage in all directions of the pipe
（2）The sizing sleeve is worn or installed incorrectly
（3）The clamping force of the haul-off machine is too large, causing pipe deformation
（4）Improper stacking of pipes causes deformation
（5）The cooling water temperature is too high, causing the pipe to soften and deform
（6）On the original basis, additional attention is needed: fluctuations in process parameters or changes in equipment status have aggravated this problem
Çözüm
（1）Check the cooling system to ensure uniform cooling in all directions of the pipe
（2）Check the sizing sleeve; replace it if worn, and ensure concentric installation
（3）Adjust the clamping force of the haul-off machine to avoid excessive force
（4）Use special storage racks for pipes to avoid stacking deformation
（5）Control the cooling water temperature at 15-25°C
（6）And strengthen process monitoring; on the original basis, additional attention is needed to pay special attention to parameter stability
Temel Çıkarım
Excessive ovality is caused by uneven cooling or external force deformation, and needs to be solved from cooling uniformity and pipe storage.
Targeted preventive measures need to be taken in different production scenarios.
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!