Material Drying
6 مشاهدة
ASA vacuum drying selection
ظاهرة المشكلة
[Problem phenomenon] High-requirement ASA products ordinary hot air drying unstable
تحليل الأسباب
Optical grade or high appearance requirement ASA can use vacuum drying to improve endpoint stability: moisture diffuses fast at low temperature and no oxidation risk; cost higher than hot air but quality stable
الحل
High-requirement parts use vacuum drying 80°C×2-3h; conventional parts hot air dehumidification suffices; drying method selected by appearance grade; after adjustment, continuously sample to verify the effect, and resume mass production after confirming stability
الخلاصة الأساسية
ASA high-end parts vacuum drying improves quality, conventional parts hot air sufficient; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a troubleshooting reference for subsequent similar problems
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!