Injection Molding
6 مشاهدة
EVA '2079851475616104452 flash
ظاهرة المشكلة
Flash on the parting line of the product.
تحليل الأسباب
EVA has good flowability and easily penetrates the parting line gap under high pressure; insufficient clamping or mold wear aggravates it.; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based on experience alone
الحل
①Check the clamping force; ②overhaul the parting line; ③lower the injection pressure; ④optimize the holding pressure curve.; after adjustment, take consecutive samples to verify the effect, and resume mass production only after confirming stability
الخلاصة الأساسية
Flash control is investigated according to clamping and mold condition; the low viscosity of EVA requires stricter parting line precision.; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!