Processing Machinery
5 مشاهدة
PARA Screw Speed and Glass Fiber
ظاهرة المشكلة
Too-high PARA screw speed damages glass fibers, destroys the interface state, aggravates floating fibers, and causes uneven strength.
تحليل الأسباب
When plasticizing glass fiber reinforced plastic, the screw speed should not be too high, to avoid excessive friction shear force damaging the glass fibers, destroying the interface state of the glass fiber surface, reducing the bonding strength between glass fiber and resin, and aggravating floating fibers; when glass fibers are long, some break and become uneven in length.
الحل
①Control screw speed in the low-speed range of 3~10m/min; ②Avoid excessive speed to protect glass fibers; ③Back pressure at a low level of 0~10bar; ④Glass fiber length retention verification.
الخلاصة الأساسية
PARA screw low-speed management protects glass fiber integrity; 3~10m/min is quantitative guidance; interface state determines the reinforcement effect.; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!