Material Drying
5 مشاهدة
PC Sheet Extrusion Bubbles
ظاهرة المشكلة
Bubbles and bulges appear inside or on the surface of PC extruded sheets.
تحليل الأسباب
The raw material contains water that was not fully dried, and water vapor forms bubbles during extrusion; failure of the vacuum venting section or hopper moisture regain also introduces gas; PC has strong hygroscopicity, and drying is the prerequisite.
الحل
①Dehumidify and dry to qualified moisture content before extrusion; ②Check the vacuum degree of the vented extruder; ③Keep the hopper insulated and moisture-proof; ④Appropriately reduce the melt temperature; ⑤Stabilize the drying system.
الخلاصة الأساسية
PC extrusion: 'water content is the first cause of bubbles, venting vacuum is the insurance': drying and venting work together; PC's hygroscopicity determines that drying must run through the entire extrusion process.
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!