Extrusion & Post
6 مشاهدة
PC/ABS delamination (melt temperature too low)
ظاهرة المشكلة
Layered peeling on part surface.
تحليل الأسباب
Too low melt temperature causes poor fusion between melt layers; material contamination can also cause delamination.; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based on experience alone
الحل
①Raise barrel temperature to within the window; ②check material purity; ③clean the barrel to eliminate contamination; ④verify whether delamination is eliminated.; after adjustment, take continuous samples to verify the effect, and resume mass production only after confirming stability
الخلاصة الأساسية
For PC/ABS delamination, first raise the temperature to verify; if raising temperature is ineffective, then check material contamination.; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!