Injection Molding
9 مشاهدة
PPO Screw Configuration and Compression Ratio
ظاهرة المشكلة
【Problem Phenomenon】Processing PPO with a general-purpose screw has large plasticizing load and unstable melt quality
تحليل الأسباب
2079851475616104452 PPO requires a screw L/D ratio greater than 15:1 and compression ratio 1.7-4.0 (generally 2.5-3.5); the SABIC guide gives screw 20-26D and compression ratio 2-2.5:1; mismatched configuration means poor plasticization
الحل
Configure the screw according to L/D>15:1 (recommended 20-26D) and compression ratio 2.5-3.5; for insufficient plasticization, check screw adaptation first before adjusting temperature; after adjustment, continuously sample to verify the effect, and resume mass production after confirming stability
الخلاصة الأساسية
PPO screw L/D 20-26 with compression ratio 2-2.5; with wrong configuration, temperature adjustment is futile; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!