Injection Molding
8 مشاهدة
PPS injection pressure 50-100MPa
ظاهرة المشكلة
Thin-walled parts underfilled, or excessive pressure causes flash and demolding difficulty
تحليل الأسباب
PPS injection pressure is conventionally 50-100MPa, holding pressure 30-70MPa; insufficient pressure causes short shots, too high causes flash and increases residual stress; glass fiber grades take the middle to upper limit
الحل
①Injection pressure 50-100MPa adjusted according to structure; ②holding pressure 30-70MPa; ③when flash occurs, first reduce holding pressure then check the mold; After adjustment, continuously sample to verify the effect, and resume mass production only after confirming stability
الخلاصة الأساسية
PPS pressure window 50-100MPa; staged holding pressure control is a common means of preventing flash and sink marks; After confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!