Extrusion & Post
13 مشاهدة
PP Printing and Coating
ظاهرة المشكلة
【Problem Phenomenon】PP products need printing and coating, adhesion is poor
تحليل الأسباب
PP has low surface energy and is non-polar, so printing and coating adhesion is poor; corona/flame/plasma/primer pretreatment is required; during on-site troubleshooting, verify item by item according to this mechanism to avoid blindly adjusting the machine based only on experience
الحل
Surface pretreatment before printing and coating (corona/flame/plasma); primer enhancement; adhesion test; after adjustment, take continuous samples to verify the effect, and resume mass production only after confirming stability
الخلاصة الأساسية
PP printing and coating must first activate the surface, only then can adhesion come up; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a troubleshooting reference for similar problems in the future
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!