Extrusion & Post
12 مشاهدة
EEA extrusion pelletizing strand sticking
ظاهرة المشكلة
During EEA extrusion pelletizing, pellets stick together, not completely cut, forming bead strings
تحليل الأسباب
EEA is soft, the knife cuts in during pelletizing but elastic recovery makes the cut faces re-bond; pelletizing water temperature too low <40°C, not fully solidified; cutter speed not matching extrusion speed
الحل
1) Increase pelletizing water temperature to 50-60°C, cut after full solidification; 2) Increase cutter speed to ensure quick cutting; 3) Cutter gap 0.01-0.02mm to ensure clean cutting; 4) Use rotary cutter instead of flat cutting to reduce strand sticking
الخلاصة الأساسية
Strand sticking is caused by elastic recovery and low-temperature pelletizing; high-temperature water cutting and fast cutting are the key
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!