Extrusion & Post
12 مشاهدة
CEF extrusion melt fracture
ظاهرة المشكلة
CEF shows severe melt fracture at too high extrusion rates, the extrudate twisted in a spiral shape
تحليل الأسباب
CEF melt elasticity too high, elastic recovery at the die exit exceeds the critical value; die L/D ratio too short <10, melt not fully relaxed; extrusion temperature low
الحل
1) Reduce the extrusion rate to 2-3m/min; 2) Increase the die L/D ratio to 15-20; 3) Increase the extrusion temperature to 160-220°C; 4) Add a small amount of low-elasticity resin to reduce system elasticity; 5) Progressive converging die entrance design
الخلاصة الأساسية
Melt fracture is caused by elastic recovery exceeding the critical value, speed reduction and longer die are the core countermeasures
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!