Extrusion & Post
12 مشاهدة
DSTDP extrusion pelletizing connected pellets
ظاهرة المشكلة
During DSTDP extrusion pelletizing, pellets are connected and not completely cut off, forming a bead-string shape
تحليل الأسباب
DSTDP is soft, the knife cuts in during pelletizing but elastic recovery makes the cut faces re-bond; pelletizing water temperature on the low side <40°C, not fully solidified; cutter speed not matched with extrusion speed
الحل
1) Raise pelletizing water temperature to 50-60°C, cut after fully solidified; 2) increase cutter speed to ensure fast cutting; 3) cutter gap 0.01-0.02mm to ensure clean cutting; 4) rotary cutter instead of flat cut to reduce connected pellets
الخلاصة الأساسية
Connected pellets are caused by elastic recovery and low-temperature pelletizing; high-temperature water cutting and fast cutting are key
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!