Injection Molding
6 مشاهدة
Large Injection Pressure Fluctuation in High-Density Polyethylene '2079851475616104452
ظاهرة المشكلة
The pressure gauge reading fluctuates greatly during injection, and the pressure difference within the same cycle or between different cycles exceeds ±5%.
Pressure fluctuation causes unstable product weight, dimensions, and quality, and in severe cases short shot or flash alternately appears.
تحليل الأسباب
(1) The hydraulic system pressure is unstable, the hydraulic pump is worn, or the hydraulic oil is contaminated
(2) The screw non-return ring is worn, and the injection amount is inconsistent each time
(3) The barrel temperature fluctuates greatly, and the melt viscosity change causes pressure fluctuation
(4) The feeding is uneven, and the plasticization amount is inconsistent each time
(5) The screw speed is unstable, and the plasticization quality fluctuates
الحل
(1) Check the hydraulic system, repair or replace the worn hydraulic pump, and replace the hydraulic oil
(2) Check the non-return ring; replace it if the wear exceeds 0.1mm
(3) Stabilize the barrel temperature, with the fluctuation of each section controlled within ±3°C (range 180-260°C)
(4) Check the feeding system to ensure smooth feeding from the hopper and a stable material level
(5) Stabilize the screw speed and back pressure to ensure plasticization consistency
الخلاصة الأساسية
Injection pressure fluctuation is caused by hydraulic system instability or inconsistent plasticization, and the hydraulic, screw, and temperature control systems need to be systematically investigated.
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!