Extrusion & Post
9 مشاهدة
Dimensional fluctuation of polyolefin plastomer extruded products (Variant: Enhanced Measures)
ظاهرة المشكلة
The outer diameter, wall thickness, or width of the extruded product shows periodic or random fluctuations in the longitudinal direction.
Dimensional fluctuation affects the fitting accuracy and service performance of the product and is common in pipe and profile extrusion.
In particular, additional attention is needed on the original basis; this problem is more prominent and requires focused attention.
تحليل الأسباب
（1）The screw speed is unstable and the discharge output fluctuates
（2）The hauling speed is unstable and does not match the extrusion speed
（3）The barrel temperature fluctuates greatly and the melt viscosity changes
（4）The raw material feeding is uneven and the feeding fluctuates
（5）The cooling water temperature or flow rate fluctuates
（6）On the original basis, additional attention is needed: fluctuations in process parameters or changes in equipment status have aggravated this problem
الحل
（1）Check the extruder drive system and stabilize the screw speed
（2）Check the speed regulation system of the haul-off machine to ensure stable hauling speed
（3）Stabilize the barrel temperature, with the fluctuation controlled within ±3°C (180-230°C range)
（4）Check the hopper feeding to ensure continuous and uniform feeding
（5）Stabilize the cooling water temperature and flow rate, and add a constant temperature device when necessary
（6）And strengthen process monitoring; on the original basis, additional attention is needed to pay special attention to parameter stability
الخلاصة الأساسية
Dimensional fluctuation is caused by unstable extrusion or hauling, and all process parameters need to be systematically stabilized.
Targeted preventive measures need to be taken in different production scenarios.
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!