Material Drying
7 مشاهدة
Silver streaks appearing on PETG injection molded products
ظاهرة المشكلة
Silver or white filamentary streaks (silver streaks) appear on the surface of PETG products, accompanied by surface roughness.
تحليل الأسباب
Raw material moisture content is too high (>0.05%) and evaporates at high temperature producing silver streaks; there is air in the barrel (insufficient back pressure); material degradation produces gas.
الحل
Ensure full drying to moisture <0.01%; increase back pressure to 0.5-1.0MPa to vent air; reduce barrel temperature and shorten residence time.
الخلاصة الأساسية
PETG silver streaks mainly originate from moisture and gas; full drying and venting are key.
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!