Clogged Head/Coating Head Clogging

When the coating method is slot-die coating, knife coating or curtain coating, the outlet is partially clogged. When this defect appears in coating-formed products, it is usually closely related to the coating head precision, the rheological properties of the coating liquid, the substrate surface condition, or the curing process conditions. The distribution characteristics of coating defects (transverse/longitudinal/random) provide important clues for diagnosing coating head and curing system problems. Continuous occurrence will cause the functional performance of the coating to fall below standard, and coordinated troubleshooting is required from three aspects: coating liquid formulation, coating equipment, and curing process.

1. Material/formulation factor: large particles or gel in the coating liquid. 2. Material/formulation factor: the coating liquid dries and cakes at the outlet during use. 3. Material/formulation factor: the material dries and hardens due to no cleaning after a long shutdown. 4. Substrate surface condition factor: The surface tension, cleanliness and microscopic roughness of the substrate are the basic conditions for coating adhesion and leveling. When the substrate surface tension is lower than the surface tension of the coating liquid, wetting is insufficient and craters occur; surface contamination leads to local adhesion failure, which is the primary direction for troubleshooting coating defects. 5. Curing process factor: the curing temperature and time determine the completion degree of the coating crosslinking reaction — insufficient temperature or time leads to incomplete curing (tacky, low hardness, poor solvent resistance), while excessive temperature or time leads to over-curing (embrittlement, yellowing, cracking), which requires precise matching to the curing window of the coating liquid system.

1. Process parameter optimization and adjustment: install a paint filter for filtration. 2. Mold/tooling improvement and maintenance: select a low-gel-tendency formulation for the coating liquid. 3. Equipment inspection and system maintenance: keep the coating head wet during shutdown or clean it in time. 4. Material/formulation optimization: perform regular automatic intermittent cleaning during continuous production. 6. Preventive management: establish standardized process parameter cards and quality control limits for each mold/product, and regularly conduct process capability index (CPK) evaluations. For recurring problems, use fishbone diagrams or the 5Why analysis method to trace the root cause, and solidify the countermeasures as PFMEA control points. Establish a regular equipment maintenance system, and implement life management for key tooling such as dies/spinnerets/calender rolls/coating heads.

This problem is a typical manifestation of clogged head/coating head clogging in coating forming. The core of the solution lies in ensuring the substrate surface condition, optimizing the rheological properties of the coating liquid, and precisely controlling the curing process conditions. It is recommended to start from the two aspects of substrate and coating liquid, and gradually troubleshoot to the coating equipment and curing system.