Molds & Tooling
3 Aufrufe
ASA Gate Mark Whitening
Problembeschreibung
【Problem Phenomenon】Obvious whitening marks after gate cutting on ASA products
Ursachenanalyse
High shear stress concentration in the gate area, cut section stress whitening; too large gate or position on appearance surface aggravates; during on-site troubleshooting, verify item by item according to this mechanism, avoid blindly adjusting the machine based only on experience
Lösung
Gate on non-appearance surface or submarine type; sharp tool trimming; slight hot air re-warming after trimming to reduce white marks; after adjustment, continuously sample to verify the effect, and resume mass production after confirming stability
Wichtigste Erkenntnis
ASA gate marks rely on position design plus sharp trimming; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a troubleshooting reference for subsequent similar problems
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!