Material Drying
2 Aufrufe
PLA Drying Temperature 80-90℃
Problembeschreibung
After the drying temperature is too high, PLA pellets stick and agglomerate, blocking the drying tower discharge port
Ursachenanalyse
PLA glass transition temperature is about 60℃; amorphous pellets soften and stick at the drying temperature; the drying temperature of amorphous PLA must not exceed 45-50℃, and 80-90℃ can only be used after pre-crystallization
Lösung
①Amorphous PLA drying temperature ≤45℃; ②After pre-crystallization, 80-90℃×4 hours; ③Crystallization equipment equipped with anti-sticking; after adjustment, take continuous samples to verify the effect, and resume mass production only after confirming stability
Wichtigste Erkenntnis
PLA drying temperature depends on the crystallization state; low-temperature pre-crystallization before crystallization is the iron rule to prevent sticking and tower blockage; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!