Molds & Tooling
3 Aufrufe
POM insufficient draft scratching
Problembeschreibung
Scratch streaks and ejector whitening marks appear on the product surface after demolding, especially severe for deep-cavity thin-walled parts.
Ursachenanalyse
POM has large shrinkage and high hardness; after gripping the core, if the draft is less than 1.5~3°, hard friction between the product and the cavity during ejection produces scratching and stress whitening.
Lösung
①Increase the draft to 1.5~3°; ②increase the ejection area and balance the ejector pin arrangement; ③polish the cavity to reduce friction; ④use release agent as a transition if necessary.
Wichtigste Erkenntnis
Scratching caused by insufficient draft continues to worsen with mold wear; reserving sufficient draft at the new mold design stage costs far less than repairing the mold afterward.; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!