Injection Molding
3 Aufrufe
PP Short Shot
Problembeschreibung
Material shortage at the end of thin-wall long-flow PP parts.
Ursachenanalyse
Although PP has good flowability, thin-walled parts have high flow resistance; low melt temperature, insufficient injection speed, poor venting, and too thin walls still cause short shots.
Lösung
①Increase injection speed and pressure; ②raise melt and mold temperature; ③enlarge the gate; ④improve venting; ⑤evaluate whether wall thickness is below the moldable limit.
Wichtigste Erkenntnis
PP short shots are mostly a balance problem of speed and venting.
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!