Extrusion & Post
9 Aufrufe
PVA extruded pipe ovality exceeds standard
Problembeschreibung
PVA extruded pipe ovality >1.05, exceeding the 1.02 standard requirement
Ursachenanalyse
Uneven pipe cooling, single-side cooling; unreasonable sizing sleeve design; uneven haul-off clamping force causes pipe compression deformation
Lösung
1) Adopt annular spray cooling to ensure uniform temperature reduction; 2) Optimize sizing sleeve inner diameter and taper design; 3) Multi-caterpillar uniform clamping haul-off; 4) Increase vacuum sizing section length to ensure full sizing
Wichtigste Erkenntnis
Ovality is caused by uneven cooling and clamping; annular cooling and uniform haul-off are the key
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!