Injection Molding
3 Aufrufe
Ejector whitening in demolding of PET injection molded parts
Problembeschreibung
White spots or cracks appear at ejection positions of PET products, especially obvious in transparent products.
Ursachenanalyse
Ejection force is too large or the ejector pin area is too small, causing excessive local stress; draft angle is insufficient; mold temperature is on the high side and rigidity is insufficient.
Lösung
Increase ejector pin area or number to disperse ejection force; increase draft angle to ≥2°; extend cooling time.
Wichtigste Erkenntnis
PET ejector whitening is the result of local stress exceeding material strength.
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!